Instructions for installation of an LTE module in a Securepoint UTM RC100 / RC200 (G5)
New article: 06.2022
Last updated:
09.2023
notemptyThis article refers to a Resellerpreview
-
notempty
Fig.1
Step 1: Loosen screws on the bottom
Fig.2
Step 2: Remove cover:
Hold cover tightly to housing: very short WLAN cable to the housing
Fig.3
Step 3: Remove SSD so that the motherboard is exposed
Fig.4
Step 4: Place LTE module on the motherboard as shown in the picture
Fig.5
Step 5: Snap the LTE module onto the motherboard the right way around and fully into place.
Fig.6
Step 6: Connect LTE module (Connection Main) to the port of the UTM using the cable
Fig.7
Step 7:
- Open the flap for the LTE card on the UTM housing.
- Insert the LTE card (see Fig.8)
- Close the flap of the housing again
Fig.8
Beveled side of the micro-SIM card is on the front left side