Konfiguration of SNMP-Monitoring
Last adaptation to the version: 12.6.0
New:
- Updated to Redesign of the webinterface
Introduction
The SNMP protocol is used for monitoring, error detection and error notification and is standardized.
The SNMP configuration of the UTM generally allows read-only access.
The UTM supports the following version of the SNMP protocol:
- SNMP version 1
- SNMP version 2c
- SNMP version 3
notempty
If this data is requested, SNMP version 3 must be used for data protection reasons mandatory!
Configure UTM
Enable SNMP
SNMP Version 1 and 2c
Packet filter rule
Für den Zugriff auf den SNMP Dienst wird eine Paketfilterregel benötigt. Diese kann unter
Button hinzugefügt werden.
OIDs
The SNMP section of the Securepoint Reseller Portal in the download area contains a .mib file that contains all OIDs currently available on the UTM with description and can be imported into common monitoring applications.
An overview of the most important OIDs that can be queried can be found in the article SNMP-OIDs .