PPPoE to Ethernet transition

---

Switching the Internet connection from PPPoE to router access

Last adaptation to the version: 12.2.5.1

New:

• Content-related updates
• Layout adjustments

notempty

This article refers to a Resellerpreview

11.7

Access: UTM-IP:Port or UTM-URL:Port
Port as configured at Network / Appliance Settings / Webserver
Default-Port: 11115
i.e.: https://utm.ttt-point.de:11115
Default: https://192.168.175.1:11115 → Netzwerk →NetzwerkkonfigurationTab Netzwerkschnittstellen

---

Introduction

The following steps must be followed to change the Internet connection from a PPPoE dial-up to an Ethernet connection with a router. The connection via the router replaces the PPPoE dial-up.

Changes to Internet connections are to be made on site only!

Requirements

The following must be known:

• The IP address of the router
• The IP address and netmask of the UTM in the transfer network

Implementation

1. Under → Network →Network configurationTab Network interfaces the zones on the wanX interface can be viewed and written down. These are then assigned to the new ethX interface. This facilitates the adoption of the network objects and the set of rules.
2. The IP address of the UTM from the transfer network to the router is placed on the corresponding ethX interface.
   
   Other devices connected directly to an internal network of the router are not secured by the UTM and may endanger the network!
3. Previously used zones can be placed on the ethX interface.
4. Now the corresponding wanX interface can be deleted by clicking .
5. Click on → Network →Network configurationTab Routing Button + Add default route. A new default route must be added using the IP address of the router.
6. Network objects must be checked for fixed IP addresses or interface names and adjusted accordingly.