Firmware installation on a Securepoint UTM
Last adaptation to the version: 12.2
New:
- Layout adjustment
notempty
This article refers to a Beta version
Preliminary remark
We do not deal with any driver problems on third-party hardware, for example.
notempty
During installation, an existing operating system on the hard disk is irrevocably overwritten
Installing the firmware
The firmware is installed in just a few steps. The preselection options only need to be confirmed.
- Display and confirmation of the license conditions
- Decision as to whether an upgrade should be carried out
Default: Upgrade - Selection of the hard disk on which the firmware is to be installed
- Starting the installation
- Request to remove the USB stick
- Reboot
- Display of the login console
| 1. | 2. | 3. |
| Abb.1 | Abb.2 | Abb.3 |
| Abbildungen | ||
Installation step 1
After the system has been started from the installation medium, the license conditions are displayed first. These should be read carefully. Click on Continue to be redirected to the next dialog to agree to the terms and conditions.
Installation step 2
The conditions must be accepted in order to continue with the installation. If the conditions are not accepted or the No button is clicked, the installation is aborted. The installation is continued by accepting the conditions and confirming with Yes .
Installation step Intermediate step
If the UTM software V11 is already installed on the device, either an update can be carried out via Upgrade or a new installation via Overwrite.
Installation step 3
The next step is to select a hard disk on which the operating system is to be installed
Installation step 4
After a hard disk has been selected, the installation must be confirmed again. If the decision has been made to carry out the installation on the displayed hard disk, this is confirmed with Yes.
Installation step 5
Information on the current progress is provided during the installation
Installation step 6
If the installation was successful, a corresponding dialog will draw attention to this.
Clicking on the OK button completes the installation.
Clicking on the OK button completes the installation.
Installationsschritt 7
The installation disk must now be removed and the system then restarted. If the installation was successful, the console login is displayed after the restart.